I was wondering if you could advise us with another problem we have with our HX1290SE machine. <BR> The laser machine arrived without any safety switches on the lid. We can retrofit generic switches without any problems but we need advice as to where to wire them in.

Question:

I was wondering if you could advise us with another problem we have with our HX1290SE machine.
The laser machine arrived without any safety switches on the lid. We can retrofit generic switches without any problems but we need advice as to where to wire them in.

Quick Answer:

The safety devices are wired into the system with the laser power supply. The best location is between the "G" (ground)terminal and the "WP"(water protection). The schematics will guide you on the proper wiring. The safety devices should've wired in series method to ensure any device failure will protect the laser tube from being damaged and from injuring a person.

Complete Answer:

https://rabbitlaserusa.com/Manuals/Install_SecondSafetySwitch.pdf

https://rabbitlaserusa.com/Manuals/Schematic_4_Safety_best.jpg

https://rabbitlaserusa.com/Manuals/Schematic_1_Safety.JPG

FAQ item was submitted:

 5/29/2012 By: Raymond L. Scott

Contact:

 Raymond L. Scott  ... Owner Engineer
ray@rabbitlaserusa.com
(513) 217-5707