Is there a way to set the number of passes? I was test cutting some 1/2" acrylic and couldn't find anyplace to tell it to cut in 2 passes. I ended up copying and pasting the same rectangle on top of itself and the machine cut it fine in two passes, but I was wondering if there was a someplace else to set it?

Question:

Is there a way to set the number of passes? i was test cutting some 1/2" acrylic and couldn't find anyplace to tell it to cut in 2 passes. I ended up copying and pasting the same rectangle on top of itself and the machine cut it fine in two passes, but I was wondering if there was a someplace else to set it?

Quick Answer:

Use the "Times" value in the LaserCut 5.3 software.. Located at the color layer.

Complete Answer:

Number of passes.

Look at the scroll bar under the Laser speed and power imputs of the software... Notice the scroll bar. Scroll to the right. There is an input for "times". This changes that specific layer to process X number of times.

FAQ item was submitted: 9/1/2011 By: Raymond L. Scott

Contact:Raymond L. Scott ... Owner Engineer
ray@rabbitlaserusa.com

Related Topics: Cut in multiple passes, Layer control, Thick Cut

www.RabbitLaserUSA.com

TobyTimes.jpg