What is the min / max values I can put in for speed, power, and corner power in cut mode?

Question:

Quick Answer:

Speed - Min should be above 0, Max should be below 1400 Power - Min should be above 0, Max is below 100 Corner power - Min should be above 0, Max is below 100

Complete Answer:

* Speed.. You should be able to use speed values from 0.1 to 1400 mm/sec * The power values are in percentage. You should be able to input 0.1 to 100.. The effective power values fully depend on the matched performance between the power supply and the laser tube. Most glass CO2 lasers will not trigger below a low-threshold and become saturated above the high-threshold. * Corner power values should be the same range as “Laser Power”.

FAQ item was submitted: 5/19/2014 By: Raymond L. Scott

Contact: Raymond L. Scott ... Owner Engineer, ray@rabbitlaserusa.com, (513) 217-5707

Related Topics: laser power, corner power, max speed